Results 1 to 1 of 1
Threaded View
-
01-18-2020, 04:25 PM #1
- Join Date
- Jan 2020
- Posts
- 1
Filament jamming - Anycubic I3 Mega
So I've been pulling my hair out over this as I can't seem to figure out what the actual problem is here.
I own an Anycubic I3 mega (had it for almost 1 year), and my fillament recently has been getting stuck in the teflon tube. It's not a nozzle clog as the fillament actually stops about 7/8 of the way to the actual print head. If I pull everything apart and replace the tube it's fine for a print or 2 then it just gets stuck again about halfway through a print. Has anyone else had this problem beforehand?
We have recently brought different filament (cheaper) and it has played up so not sure if that could be an issue either
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion