Results 1 to 1 of 1
Threaded View
-
11-26-2019, 02:20 PM #1
- Join Date
- Nov 2019
- Posts
- 1
Alfawise U20 ONE - Stops extruding on just one print job?!?!
Hello,
I recently got a U20 One which I'm really enjoying.
All my prints have worked beautifully except one.
I printed the base for this one and it printed perfectly: https://www.thingiverse.com/thing:2493459
Except, it was the wrong size for my stone. I uploaded it to tinkercad and extended the sections I needed and exported as an stl. Threw it into cura and exported the gcode.
About half way through it stops extruding and even makes a weird noise in the area that grabs the filament. I figured it was I was printing too fast or not hot enough so printed 5 different versions at different speeds and temps...all did the same thing.
If I print anything else, it prints fine...just did an eight hour print with any issue. So what's happening to this one? The one other factor is that the print has a large footprint but is still within the guidelines of this printer.
Any help would be amazing!
I've attached my modified stl.
Thanks!Last edited by mtlred; 11-26-2019 at 02:33 PM.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help