Results 1 to 4 of 4
Thread: Model starts printing above bed
Threaded View
-
09-05-2019, 07:19 PM #1
- Join Date
- Sep 2019
- Location
- The Great Northwest
- Posts
- 2
Model starts printing above bed
I've printed a couple dozen items on my Anycubic Kossel Plus successfully. Today I tried printing a file and the extruder started laying down filament about 2" above the bed. The Cura model looked like it was sitting on the bed. I rebooted and tried a file I'd done before and it printed normally. Both files were sliced with Cura 4.2.1. What can I check to make sure the file begins on the bed?
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion