Results 1 to 5 of 5
Thread: Dremel 3D20 Printing Help!
Threaded View
-
06-16-2019, 07:56 PM #3
- Join Date
- Jun 2019
- Posts
- 5
Hello curious aardvark! Thanks for replying!
Yeah, I'm printing via SD. I'm printing PLA at a (default) temperature of 220?C. I've read that this temperature might be too high - and it may be, as I believe some of the material leaks towards the end.
I too have read that those markings can be adjusted via the retraction settings. I've since adjusted some values since. This is my current setup:
- Initial Printing Temperature: 210?C
- Printing Temperature: 210?C
- Final Printing Temperature: 205?C
- Retraction Distance: 3 mm
- Retraction Speed 25.0 mm/s
- Retraction Extra Prime Amount: 0.5 mm ^3
- Additionally, I've enabled the Z hop when retracted setting, "Hopping" at a height of 1 mm.
I'm still seeing some markings on the top layer and some under extrusion on the first layer.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help