Results 1 to 2 of 2
Thread: Problem Printing TPU
Threaded View
-
06-16-2019, 06:40 AM #1
- Join Date
- Feb 2016
- Posts
- 68
Problem Printing TPU
I have a Cocoon Create/Wanhow Duplicator i3 V2 printer and have printed a couple of small pieces of TPU before but now it prints the skirt and will not print any more.
The TPU goes in but comes out continually and no filament goes in the nozzle. When I pull the feeder apart the TPU is squashed up where it goes past the feeder.Seems like the TPU is too soft.
I did squash up a bit the plastic tube above the nozzle and rounded it as best I could. I have ordered another one but prints PLA and the four rounds of Skirt with TPU all right.
Anyone help with this?
EDIT:This time it was feeding earlier on when doing the skirt and the TPU was going through and kept feeding too much as in the photo.Last edited by Firepower; 06-16-2019 at 08:06 AM.
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion