Results 1 to 5 of 5
Threaded View
-
06-15-2019, 10:25 PM #3
I would start by removing the G28, I know it is only supposed to home the X axis, but I dont think you the "X0". I beleive you only need the "G28 X".
Not sure why you want to re-home just the X Axis you could just do a G0 X0, that will move X to the 0 position without running the home routine.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion