Results 1 to 1 of 1
Threaded View
-
05-05-2019, 10:54 AM #1
- Join Date
- May 2019
- Posts
- 4
need help with first layer after raft
i need to use the raft for printing this little part, the first layer of the part look under-extruded, with gap
test1.jpg
Then I tried to increase the bottom layers for 2 to 5, same identical result
test2.jpg
Also tried to increase "above raft speed" from 50 to 100%
test3.jpg
With no raft the part is obviously good
test4.jpg
I am using S3D 4.1.1Last edited by zfrenchy; 05-05-2019 at 11:00 AM.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help