Subscribe to Our Newsletter Advertise
Close



Results 1 to 3 of 3

Threaded View

  1. 04-21-2019, 01:13 PM #2
    Roberts_Clif
    Roberts_Clif is offline
    Staff Engineer Roberts_Clif's Avatar
    Join Date
    Jun 2017
    Location
    Washington State, USA
    Posts
    1,151
    Add Roberts_Clif on Thingiverse
    Hello;

    I looked at your Sliced model using idealMaker by Rasie3D Image below.

    Image2.jpg

    Then I download the Models from Thingiverse an re-sliced saved the model G-Code.
    Viewed model using idealMaker by Rasie3D Image below.

    Image4.jpg

    As you can see your model top was somehow sliced wrong, causing the stringing.
    Your sliced model should look more like the model on the bottom that I had sliced.
    Last edited by Roberts_Clif; 04-22-2019 at 07:16 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules