Hi all,
I have an Ender 3 and I think I have my settings dialed in, but have some issues I don't know how to fix.
E-Steps have been calibrated.
Speed 50mm/s
Temp 240C and 70C
Retraction 6mm and 40mm/s

There is a small 'blob' on the front left corner (pic 1)
There are some weird 'blobs' on the front deck (pic 2 & 3)
There are some strange markings on the back right side quarter (pic 4)
Appears to be evidence of something like elephant foot on the corners of the rear boxes behind the main pilot house (pic 5)
The rear deck has a similar issue to the front with blobs (pic 6)
The writing on the bottom is 'messy' (pic 7)
The sides of the pilot house, and the sides of the roof, is this salmon skinning? (pic 8)

Please and thanks

*edit: Just realised that I can't attach all 8 pics. Second post will have the remaining 3

Thanks

1.jpg
2.jpg
3.jpg
4.jpg
5.jpg