Results 1 to 10 of 32
Thread: 3d printing at home setup
Threaded View
-
03-21-2019, 06:32 AM #11
alice was a spam bot :-)
Bear in mind that you can always stack printers. People tend not to think vertically.
My mini delta sits on top of my normal sized delta.
You could make a simple legged shelf (table) and use the vertical space in your office :-)
some 2x4 a piece of plywood and 8 screws (2 per leg, screwed down through the plywood). job done.Last edited by curious aardvark; 03-27-2019 at 12:08 PM.
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help