Close



Results 1 to 10 of 11

Threaded View

  1. #1

    Support Touching Buildplate not printing fully

    I have a Cocoon Create/ Duplicator i3 v2 printer and can not get the Support touching buildplate to work with out breaking up all the time with PLA+. I just used PLA and it worked all right but PLA+ comes out bad as per the photos.

    I just changed the Fill Amount from 15% to 30% but it works slightly better. I have tried Bed temperatures from 40 degrees to 70 degrees and the print head from 190 to 230 and still bad Support.

    It starts to print good but after a few rows the print is all broken up in the Support only. I just changed the Fill amount from 15% to 30% and is was good enough to print the item but the Support was not too good.

    Can I make the thickness of the Support thicker in the Cocoon Create program as that would work as the items print good.
    Attached Images Attached Images
    Last edited by Firepower; 03-21-2019 at 12:11 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •