Results 1 to 5 of 5
Threaded View
-
02-12-2019, 01:48 PM #3
100psi - Hmm.
What shape is the tank going to be and what orientation are you going to print it in.
A rectangle with a hollow interior could work as you culd print it lying down and then wrap it in some really shit hot sticky tape.
I can't see it holding pressure unless you seal it or wrap it in fibreglass resin, or something similiar.
In short - it's probably not going to work.
Black vinyl plumbers tape could work.
It self anneals and if you wrap it with stretch, it exerts a decent amount of compression.
So print the tanl. Wrap it in a couple layers of stretched black vinyl plumbers tape (other coklours are available) then seal it with some kind of paint on resin.
If it still blows up - it's not my fault :-)
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help