Results 1 to 10 of 23
Thread: Wobbly print
Threaded View
-
01-15-2019, 11:47 AM #21
- Join Date
- Jan 2019
- Posts
- 12
I do not have anything to compare with my thoughts is that it could be the problem. That it gets stuck, doesn?t feed enough filament then after a while it gets pulled loose and the print looks good again for a while. I have print with slower speed ongoing. If it fails, I will cut a piece of filament and use that instead of a whole spool again. And if that works I will increase the speed again
Last edited by skvalp; 01-16-2019 at 05:20 AM.
BambuX1Carbon($2k) vs MarkTwo($20k)
05-31-2024, 12:45 PM in 3D Printers (Hardware)