Results 1 to 10 of 23
Thread: Wobbly print
Threaded View
-
01-13-2019, 06:30 AM #12
Could it be that the filament is getting tangled.
Select a small model, slice and get a measurement of the amount of filament cut to length + a little extra.
Loop the filament over the Spool holder and Print.
I have had filament rolls that were a tangled mess. when I examined filament it was not tangled.
Only by recording did I determine that the Filament was indeed tangling.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion