Results 1 to 7 of 7
Thread: Oversized model
Threaded View
-
01-09-2019, 06:47 AM #7
guess it depends what design program you are using.
In openscad I'd make a very large torus and use a section with the same curvature as the bridge to make the channels.
I think most whysiwig design packages let you curve things, so probably much easier :-)
If you can curve the bridge, you should be able to curve a long thin cylinder to the same degree. Then just remove it from the bridge.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion