Results 1 to 10 of 18
Thread: Monoprice Mini Delta Review
Threaded View
-
01-06-2019, 01:18 PM #18
50% reduction in all directions - so 8x smaller than the normal size cube.
Also dropped the gap down to -0.1
Printed a 25% one out, looked good but fell to bits when you tried to move it.
Going to work up in 5%'s till I get the smallest one I can make :-)
here's the 50% in action:
Last edited by curious aardvark; 01-06-2019 at 01:26 PM.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion