Results 1 to 2 of 2
Threaded View
-
01-04-2019, 08:28 AM #2
- Join Date
- Dec 2018
- Posts
- 4
Wow, nobody has an idea?
Well I have a wild theory then...
If you look closely at my model I made a really bone-headed mistake. It's hard to tell at that angle, but I combined all meshes and then applied a bend deformer to the shield. However, I didn't even think about the shield itself not having the proper subdivisions for bending. The quick radial extrusion method I used caused the lettering and graphics to become disconnected from the faces of the shield. The result was a lot of floating objects and a single attachment point. I didn't even notice it until further inspection.
So, with all that said.. is it possible this terrible geometry threw everything off in the scaling somehow?
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help