Results 1 to 4 of 4
Thread: Ender 3 Build Space usage
Threaded View
-
12-24-2018, 06:46 PM #1
- Join Date
- Dec 2018
- Posts
- 2
Ender 3 Build Space usage
Hello there,
I?m new to 3D printing but able to resolve most problems myself.
Recently I encountered a problem with a very large piece that almost uses the whole build surface. While printing with a brim I noticed that the round piece got cut of at the edges of the build surface. The printer refused to print a curve, just ignored the G-Code and printed a straight line following the shape of the build surface.
Cura didn?t show any of this and there was a good min 1.5 cm headroom to all edges.
Is there a set value of boundaries in the Marlin firmware?
Didn?t find a solution on google or the search function in this forum.
Any help is appreciated.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion