Results 1 to 1 of 1
Thread: Help with MKS Gen L V1.0 Ender 3
Threaded View
-
12-21-2018, 03:35 PM #1
- Join Date
- Nov 2018
- Posts
- 28
Help with MKS Gen L V1.0 Ender 3
Hi all so when i connect to my new MKS GenL board i get the below picture. It says device has an issue. I have trouble programming ir because it shows under USB af a fault instead of as a com port.I have VP installed and when i connect to the old Ender 3 board i get a com port.I dont know what direction to go from here ?Help RobertUpdate it turns out being new got me again. I didn't know i needed to install the stepper drivers on this board. They are in the mail. Ya learn something everyday and sometimes every hour in the 3d print world
Last edited by RobertR728; 01-01-2019 at 07:41 PM. Reason: Forgot the pic
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion