-
Student
No luck slicing a small, thin walled cylinder.
For a fact, this object has been printed by a few people through 3DHubs. I know the design is fine and the outcome is nice. Smooth walls. However, since I finally got a printer. I tried using Cura and Slic3r (shown). No luck! There must be a trick!
Imported -> Sliced.
1.jpg2.jpg
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Ender 3v2 poor printing quality
10-28-2024, 09:08 AM in Tips, Tricks and Tech Help