Results 1 to 5 of 5
Thread: Supports not sticking to bed
Threaded View
-
11-08-2018, 12:06 PM #1
- Join Date
- Nov 2018
- Posts
- 1
Supports not sticking to bed
I need some suggestions on getting my supports to stick to my printer bed. I?m using a Davinci Pro 1.0 with an aluminum bed. I have a borosilicate glass plate on top of the aluminum bed and I have been using hair spray with pretty good results. I recently switched to using a glue stick on top of the glass plate but the problem I am having is the supports are not sticking, I think because they are so small and really don?t have enough surface area. The other parts of the prints that have a little more surface area on the glass stick very well. I have ordered one of those two piece magnetic build surfaces that comes in tomorrow that I can try but other than that I have run out of ideas. Does any one have any suggestions?
Thanks in advance.
Tom
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion