Results 1 to 4 of 4
Threaded View
-
11-04-2018, 12:03 PM #1
- Join Date
- Nov 2018
- Posts
- 2
PA12 HP MuliJet Fusion ( nylon polyamid ) bonding
Hello,
I'm designing a Rapala lure prototype ( 17cm long ) and I need to stick together two half parts of it but I'm wondering which glue to use
the wall tickness is thin ( around 1.75mm ) even if there are larger bonding area ( the head and the tail ) so my fear would be a melting and the strengh of the bonding too even if for that I'm going to use an additional system by using a special shrink tube who shrink immediately with boiling water
Thanks by advance
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion