Results 1 to 2 of 2
Thread: First layers squished?
Threaded View
-
08-08-2018, 10:14 PM #1
- Join Date
- Aug 2018
- Posts
- 2
First layers squished?
So at first I thought it was elephants foot. But alas it is not. 1st layer lays down perfect, but layers 2-6ish the nozzle doesnt seem to raise anywhere near enough. After that the print continues on just fine. It seems to only be a problem on solid prints like a brim or a raft (or the top part first few layers of a petsfang) Any ideas?
TEVO Tornado Gold Edition
PLA 210/60
30mm/s bottom and top 2 layers, 60mm/s print.
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion