Results 1 to 10 of 24
Threaded View
-
04-07-2018, 04:29 PM #21
- Join Date
- Mar 2018
- Posts
- 11
I did check the RPi3 spec sheet and the numbers are correct. As for the 25.62: the lighting over my work area was dimmed from a dead bulb and i could'nt see that the caliper wasn't properly lined up haha. My bad.
I would like to thank everyone who has been helping me with this complete this project. I've learned quite a bit more than i thought i knew from my father. Biggest lesson i learned: dont FULLY trust SketchUp lol
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion