Results 1 to 9 of 9
Threaded View
-
12-02-2017, 10:19 PM #1
Getting a Flat finish rather than a glossy finish
Just wondering if anyone ever printed to get a flat final finish.
Everything I print is usually glossy finish since I print on Kapton tape primarily. PLA.
Other than getting a piece of sandblasted or frosted glass.....anyone know of a good way to get a flat finish?
Sure, I "could" sandblast the finished build, but that's not convenient.
Would save a ton of trouble to get a flat finish off the printer.
Ideas? Suggestions?
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion