Results 1 to 2 of 2
Threaded View
-
10-11-2017, 07:15 PM #1
- Join Date
- Oct 2017
- Posts
- 4
Stringing problem printing gear teeth
Printer: Creality CR-10
Filament: PLA
Slicer: Cura 2.7.0
Experience level: Noob
StringyGear.jpg
As you can see in the picture, I'm getting some major stringing between the teeth on this small herringbone gear. I'm fairly sure the problem is with the slicing, rather than the printer. The large gear that goes with it printed beautifully. I have combing mode set to "all", which I think should avoid moving straight over the space between teeth, but apparently it's not working.
Any ideas on other settings to try?
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion