Results 1 to 10 of 10
Thread: Strange slicing in S3D
Threaded View
-
10-03-2017, 12:28 AM #1
- Join Date
- Jul 2017
- Posts
- 193
Strange slicing in S3D
I went to print a new effector for my He3d K200 so I had a spare to try to create a new blower type part cooling duct, and when the print finished , I could see through it in one line across the part. I used Simplify 3d 4.0. Up to now, it had performed flawlessly on the few prints I made. Looking at the slicing later by layer, you can see that it creates rectangle where none really exists. I have a side by side comparison of S3D on the left, and Cura 2.7 on the right. You can see the continuous seam top to bottom. Does anyone know what settings I can change that will change the slicing behavior?
Top Layer - You can see the rectangle exists in S3D, but not Cura
effector-40.jpg
Mid layer, you can see the seam continue (layer 25 of 40 )
effector-25.jpg
First Layer, you can see that it starts at the very bottom.
effector-1.jpg
Thoughts?
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery