Results 1 to 10 of 13
Thread: Anet a8 Def error ohm reading
Threaded View
-
09-08-2017, 03:13 PM #1
- Join Date
- Sep 2017
- Posts
- 35
Anet a8 Def error ohm reading
Hi!
I just finished building my Anet A8 printer. The first print worked fine, I set it to "cooldown", then unplugged it after a few mins. Now, a few hours later, it will no longer print. Both temps say "def".
I have:
Soldered the heatbed wires on the heatbed
Re-soldered the thermistor on the heatbed
The ohms are as follows: Extruder; 110-120k ohm
Heatbed: 55-59k ohm
(unconnected)
When the heatbed is connected to the mobo, it measures 5.7k ohm. The extruder measures 16-17ohm when connected.
Any suggestions?
Cheers
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery