Results 1 to 3 of 3
Threaded View
-
08-02-2017, 09:00 AM #1
- Join Date
- Aug 2017
- Posts
- 1
Is it possible FDM-PLA parts stronger* than Injected Moulding?
I've come across with some research showing stronger PLA-FDM parts under tensile and compression stress in longitudinal and transverse directions than Injected Moulding of the same material, as showed in Measurements of the mechanical response of unidirectional 3Dprinted, SONG 2017 (see attached image)
And the conclusion of the reseach states that :
"3D-printed PLA is tougher than injection-moulded PLA. This is due to the layered
and filamentous nature of the 3D-printed material and the complexity that this
induces in the microscopic mechanisms of fracture."
Most studies with ABS shows that air gap and lack of strength in filament bonding decreases strength* in FDM parts.
My 3D Norn Emissary print
09-13-2024, 02:28 AM in 3D Printing Gallery