Results 1 to 4 of 4
Threaded View
-
07-25-2017, 10:29 AM #1
- Join Date
- Jul 2017
- Posts
- 8
Modeling tolerance question for inserts, hardware, hinges, etc.?
I just received my Creality CR-10. I’ll be using it to makesitems like the picture. (approx. 2.5”-1.5”) My questions regards tolerancesfor modeling. e.g. The nut for the clamp fits into the recess. The screw goesthrough the hole. Any suggestions on a tolerance for easy insertion that’s notto slack? Would tolerances be different for different materials, PLA, ABS,Nylon, etc.? I realize each material may have different requirements, I’m justlooking for a place to start.
Also, how precise is a printer like the CR-10? My clamp doesnot currently have the edges filleted. However, I do not want them to be sharp. Should Ifilet the edges in the model, or it the print resolution such that the edgeswould not be sharp?
clamp.jpg
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion