Results 1 to 10 of 101
Thread: Network Printers
Threaded View
-
06-28-2017, 09:15 PM #11
I have been trying to get the extruder set up. I drew up and printed a small piece to hold the proximity sensor, then I made a piece to attach the wires to and got to this point..
While the proximity sensor is held firmly in position the other piece kinda pivots a little on the one screw that holds it in place. This and the pursuit of perfection has made me draw up a replacement piece..
And the part is printing.
Qidi X Plus 3 Paper thin first...
05-27-2024, 01:15 AM in General 3D Printing Discussion