Results 1 to 10 of 22
Threaded View
-
03-29-2017, 01:53 AM #21
- Join Date
- Jan 2016
- Posts
- 41
I am still fighting with the right temperatur. I tryed to print 2 Fischertechnik bricks with a lenght of 9cm. With the temperatur setting of the fan duct i got warping.
The folliwing values were successfull :
Chamber temperature - 150C
Powder surface - 174.6C
Speed - 750mm/s
With lower speed i got aways warping. But with this values it was very hard to get the object free from powder.
After this i tried to print an object that has less big printed areas.
Chamber temperature - 150C
Powder surface - 171.7C
Speed - 450mm/s
It was important to lower the speed. The result was great. Easy to clean and no warping.
I am still searching for the right setting to print an object. I am not shure when big printed areas makes an problem....
Cura slicer issue
09-13-2024, 02:44 AM in 3D Printing Slicer Discussion