Results 1 to 5 of 5
Thread: Unistalling firmware?
Threaded View
-
01-14-2017, 06:09 PM #1
- Join Date
- Jan 2017
- Posts
- 10
Unistalling firmware?
This is kind of a cross post from the CTC forum.
Hello all, new to this forum and new to 3D printing.
Im having a problem with my printer, CTC Duplicator 4 Dual, that I got last week. On my first prints using Autodesk Fusion 360 and my projects downloaded onto a SD card, the printer worked great, although the prints were about 5% smaller than the actual drawing. The problem started when I downloaded the suggested firmware, RepG, Makerware, onto my printer. Im using Mac OS so I used ReplicatorG-0040.dmg to upload and after this firmware was installed, my printer froze, 2 horizontal bars and the buttons froze. Now when I turn on the machine the only thing that happens is the build table heats up, if RepG is open or not. Also, I thought that maybe I could print using this firmware, it looks like it going to print, then it fails.
I was asking if anyone would know how to uninstall this firmware to get my printer back to the factory settings as it was before...Thanks
Holes and pockmarks in print walls
Yesterday, 09:14 AM in General 3D Printing Discussion