Results 1 to 10 of 50
Thread: The curse of ABS (Warping)
Threaded View
-
10-20-2013, 11:48 AM #11
Haha, Well it isnt one of the best i had ^^
http://puu.sh/47KmU
Is one my coolest prints imo ^^
Well its a bulb or a box so the heat stays inside i guess.
Well i will see, Its that or a box, or i might just use ABS for small parts and when i wanna print bigger stuff i will have to use some nice PLA :P
Thanks for the help guys,
As side note i realy like how this community is growing with some very nice members, Realy hoping the best atm
Edit:
Didnt see your post, you probably made yours when i was posting mine ^^
Well i have 2 fans, One is always on and thats blowing air on the PEEK of the hot end, the other on the plastic, The one with a funnel to the plastic is controlable and is only on when i use PLA not with ABS.Last edited by DrLuigi; 10-20-2013 at 12:21 PM.
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help