Results 1 to 2 of 2
Thread: QU-BD Two up settings
Threaded View
-
12-28-2016, 10:59 PM #1
- Join Date
- Dec 2016
- Posts
- 1
QU-BD Two up settings
Does anyone know the eeprom settings for the two up?
When I received my printer there wasn't anything on the board when I hooked it up to repetier.
I can't seem to get it to move accurately either in mm or inches.
If anyone has the eeprom settings, it would be gratefully appreciated.
Thank you
Holes and pockmarks in print walls
Today, 09:14 AM in General 3D Printing Discussion