Results 1 to 6 of 6
Threaded View
-
12-27-2016, 12:20 PM #1
- Join Date
- Apr 2016
- Posts
- 28
Dual print failure- 2nd head prints a bog blob!!!
Folks, Ive been trying dual printing for a change.... but hitting some issues.
I'm running Saolfish firmware and S3D as the slicer.
managed to calibrate the tool offset by hand since Sf seems to have a bug which prevents makerware calibration strips from working.
so anyway...
I create a Dual printing in S3D (using the wizard) all is well until the second head starts to print the ooze shield, then it extrudes a giant blob before starting to print.
It's like it's clearing itself...
But I already have start g-code that runs a strip accross the front of the build plate.
I also have a skirt at 10mm out and ooze shield at 5mm out, so can'r figure it out....
This might be an S3d issue ?
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help