Results 1 to 10 of 11
Thread: I really need some help!
Threaded View
-
12-18-2016, 04:01 PM #1
- Join Date
- Dec 2016
- Posts
- 5
I really need some help!
Hi.
I own a Sharebot NG (Single extruder head)
I got it second hand at a good price. After that i taken the printer to a 3d printer service where she was checked / some parts changed / calibrated and finally arrived at my house.
But now the problems :
I have some issues with the prints (see in imgur album at the end) The speed is set at 45 (Simplify3D 2700mm/min = 45) Also in printer quick settings 45%)
That is not the only software i used to print them but on all i had the same print settings. I have also added all the Simplify3D settings maybe someone figure out what is the issue or why.
The printer it`s on a big shelf very hard to move (So the printer was not moved during print or the shelf moves when the printer prints)
http://imgur.com/a/u5b0l (Settings on Simplify3d)
http://imgur.com/a/ghmue (Picture with failed prints)
Thanks in advance
New member with print issue
06-11-2024, 08:57 AM in Tips, Tricks and Tech Help