Hi all!

I'm printing on a Vellemann K8200.

I have run into these printing issues(look at picture).
The bottom plate prints flawlessly without any weakness or warping, however, when the "pillars" is to be printed they end up as shown in the picture.

I have tried tweaking these settings for the different prints:
- Raising print bed temp to 55C.
- Raising extruder temp to 195C.
- Disabled fan.
- Running fan at 100%.
- Slowing print to 20mm/s.
- Slowing print to 10mm/s.

The filament is PLA.

Still no noticable improvement.
Any ideas?

2014-03-23 16.12.02.jpgkuggar2.jpg