Results 1 to 10 of 125
Thread: Wanhao Duplicator I3 3D Printer
Threaded View
-
12-09-2016, 06:22 PM #36
- Join Date
- Dec 2016
- Location
- Jacksonville, FL
- Posts
- 2
Hello folks. Hope I can get some newbie assistance here.
I just bought a Monoprice Maker Select V2 which, I am told, is a rebranded version of the Wanhow Duplicator. My problem is trying to set up Cura.
What settings do i use? I attempted to do a "Custom" printer setup and waded through all the (thousands???) of settings but in the end, Cura does not recognize the printer is even plugged into the USB port. I can print from the micro card and the test parts included with the printer pre-installed on the card print OK, but I would really like to print from Cura if possible.
Any help would be appreciated.
Tom
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help