Results 1 to 7 of 7
Threaded View
-
12-09-2016, 11:31 AM #1
New Problem - What happened here? - Photo
Never had this particular issue. Seems everything was going fine then this.
The bottom 1/2 inch or so printed normally, there should have been another inch that looked exactly like the bottom part that printed ok.
Instead the upper last inch came out as a bird's nest.
This exact same file printed fine previously so I don't think it's the x3g file
Reprinting now with the Right extruder and it's at 80% (far past this point) and doing fine.
Left extruder issue?
Holes and pockmarks in print walls
06-04-2024, 09:14 AM in General 3D Printing Discussion