Results 1 to 8 of 8
Thread: [VIDEO] Prusa X-Axis Wobble
Threaded View
-
11-02-2016, 04:26 PM #8
- Join Date
- May 2015
- Posts
- 49
I replaced bearings and rods and it did improve things to the point where I wasn't getting any more wobble/looseness.
What I found was that the old bearings were actually OK (or perhaps more standard), it was the rods that were undersized. I mic'd both the old and new rods, and the old rods were slightly smaller diameter. I probably could have gotten away with just replacing rods, but there was no way to tell in advance. But just because my rods were the issue doesn't mean that will follow for your problem (that is, assuming you can actually see a sloppy fit between your bearings and rods). As always, your mileage may vary.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help