Results 2,331 to 2,340 of 4110
Thread: Qidi Tech 1 - Replicator 1 clone
-
07-13-2016, 06:12 PM #2331
What printer type are you choosing? It should be closer than that unless you choose Replicator 2. The Qidi is a Replicator 1 clone. There is a difference in the X/Y drive system between the 2.
Don't bother with 20mm tall cubes, 10mm is enough. They should be 100% infill also.
-
07-13-2016, 06:15 PM #2332
- Join Date
- Jul 2016
- Posts
- 3
-
07-13-2016, 06:22 PM #2333
-
07-13-2016, 06:24 PM #2334
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-13-2016, 06:26 PM #2335
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
-
07-13-2016, 06:40 PM #2336
- Join Date
- Jul 2016
- Posts
- 3
-
07-13-2016, 06:56 PM #2337
-
07-13-2016, 07:26 PM #2338
- Join Date
- May 2016
- Posts
- 55
That's about what I would get with my ReplicatorG/SkeinForge setup. Now I'm on Slic3r, and that's pretty much spot on in X and Y. I think it might be a little bit off in Z, but I haven't tested that yet. X and Y were easily tested on a print I did to test a snap fit design for my next project.
-
07-13-2016, 07:47 PM #2339
- Join Date
- Jun 2016
- Location
- Oklahoma
- Posts
- 904
What are you guys using for extrusion width and multiplier for ABS and PLA? I think I am having sizing issues. I have the nozzle diameter set at .4.
How have you calibrated the print size?Last edited by wirlybird; 07-13-2016 at 07:58 PM.
-
07-13-2016, 07:57 PM #2340
- Join Date
- Aug 2014
- Posts
- 627
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help