Results 1 to 1 of 1
Thread: Repetier firmware setup offset
-
05-09-2016, 09:18 PM #1
- Join Date
- Dec 2014
- Posts
- 5
Repetier firmware setup offset
Hi,
I changed the firmware and controller on my Prusa I3 style printer. I move to Repetier .92 on an MKS board. Question is, what is the proper way to set up an X axis offset. My X homing position is 35mm from the edge of the print table. Would this be set as a min X, extruder offset, or some other setting?
Thanks
Joel
Qidi X Plus 3 Paper thin first...
Yesterday, 01:15 AM in General 3D Printing Discussion