Results 1 to 6 of 6
Thread: what a nozzle idea
-
09-28-2015, 07:35 PM #1
- Join Date
- Sep 2015
- Location
- South Australia
- Posts
- 89
what a nozzle idea
in regards to the nozzles, what size socket are using to remove them,? I have used a 9mm socket on my torque wrench, but feels a bit loose, are they metric?
also do you have any tips on holding the aluminum blocks without damaging them in the nozzle change procedure?
-
09-29-2015, 12:37 AM #2
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
If it is very tight I remove the heater and put a silver steel bar down the hole.
-
09-29-2015, 12:53 AM #3
- Join Date
- Sep 2015
- Location
- South Australia
- Posts
- 89
-
09-29-2015, 01:13 AM #4
- Join Date
- Jun 2014
- Location
- Burnley, UK
- Posts
- 1,662
There is only one hole when you remove the heater, the hole where the heater fits.
-
09-29-2015, 02:44 AM #5
- Join Date
- Sep 2015
- Location
- South Australia
- Posts
- 89
-
09-29-2015, 05:25 AM #6
on my creator x I stick an alen key into the aluminium block (there is asocket) and use that to hold it still.
No idea what socket I use - it was just the one that fitted - never looked at the size :-)
My big problem is actually finding replacement nozzles that have the right sized shaft for the ptfe guide tube.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help