Results 11 to 13 of 13
Thread: What have I done wrong ?
-
09-02-2015, 06:35 AM #11
- Join Date
- Aug 2015
- Posts
- 18
Hmmm,
Found no on board reference to turning the extra fan on, anyone else had to address this issue on the Pro Yet.
Cheers
-
09-02-2015, 12:07 PM #12
- Join Date
- Aug 2015
- Posts
- 31
i think that is subjective.
it depends on your printing platform.
if you have glass with glue, or tape, or buildtak directly on your build plate..
etc.
it will vary based on what you are printing on and how many layers you have on top of that and what material you are using.
some thing conduct heat better than others.
If you set your bed at 95 and hit with an infrared thermometer it should read ~95, but if you have 1/8 glass or 1/4 glass or something else.
maybe with tape on that or PEI or something. that won't read 95
for abs i set my bed to 110, using 1/4 glass with hair spray and have no issues to speak of.
-
09-15-2015, 11:27 AM #13
- Join Date
- Oct 2014
- Posts
- 93
sorry to state the obvious but if its a flat topped model, just rotate it, so the flat at the bottom ie print it upside down, then there is no overhang issue ???
Resin has changed after...
06-18-2024, 10:34 AM in General 3D Printing Discussion