Results 21 to 24 of 24
-
04-14-2015, 10:38 AM #21
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
-
04-15-2015, 07:26 AM #22
-
04-15-2015, 07:27 AM #23
-
04-20-2015, 04:17 PM #24
- Join Date
- Mar 2015
- Location
- San Diego, CA
- Posts
- 107
Well, I think I've finally got a part that's close enough fit.
One surface that looked flat is actually sloped. My first cut had a same sized edge overhang all the way around, but the actual part varies continuously with a couple of notches.
All told I spent a good 5 hours and 3 prints. Would be nice if there were a good scanning service.
Printer will print perfect...
06-14-2024, 10:44 AM in Tips, Tricks and Tech Help