Results 11 to 12 of 12
-
03-16-2015, 11:13 PM #11
I only had one PLA filament. And since I was getting really good results with ABS, I had not pursued this again. But I now have a few sample PLA filaments on hand and I will need to revisit this.
This is in a PEI plate on the Taz5. I have had very little issue with warp with ABS. The only issue I have had to date was printing a 10" LED light strip that was not very tall (Z axis). It wanted to curl on the ends. I added extra pads on the corners and it printed just fine.
I am not saying I did things right. Just saying its been working.
I am willing to entertain suggestions as to what to change or improve. I would dearly love some constructive feedback as to procedures and settings.
-
08-10-2017, 12:24 PM #12
- Join Date
- Aug 2017
- Posts
- 6
I have the same problem on my printer that is in my garage. When it is over 95F outside, I can not print. I usually try printing when a storm blows thru and the temp drops to about 75-80f. I am in the process of making a machined part to add water cooling. I'll post if it works out well
New Here, don't print but need a...
06-20-2024, 12:18 PM in General 3D Printing Discussion