Results 1 to 1 of 1
Thread: Following on from Mars, Earth!
-
02-28-2015, 12:31 AM #1
- Join Date
- Jan 2015
- Location
- Milano, Italy
- Posts
- 10
Following on from Mars, Earth!
Since my Mars print was quite successful, but a bit wibbly I thought I'd do a print of the Earth. Mars was wobbly because I tried to print the whole sphere, and the southern pole of the sphere does not have a huge area for the print to rest on...
So I've done the northern hemisphere of the earth (again using DEM greyscale files and PhotoToMesh):
Just as in the Mars print I've exagerated the elevations, else they would have been too small to see really, even on a 150mm hemisphere like this is.
New to 3d printing looking for...
05-20-2024, 12:56 AM in Tips, Tricks and Tech Help