Close



Page 4 of 4 FirstFirst ... 234
Results 31 to 33 of 33

Thread: Black ABS

  1. #31
    Super Moderator Roxy's Avatar
    Join Date
    Apr 2014
    Location
    Lone Star State
    Posts
    2,183
    Quote Originally Posted by RobH2 View Post
    So, I now have applied that workflow to all my filament even when I'm not clearing a jam. Before I remove or swap a filament, say ABS, I set the head to about 110C and let it sit for a few minutes. Then I slowly pull that filament out with some needle nosed pliers. I grab the filament near the hinge and rest the tip on the top of my extruder body's surface. I then lift the pliers very, very slowly, by the handles.
    You mean 210C don't you? 110C and it won't even get soft????

  2. #32
    Super Moderator RobH2's Avatar
    Join Date
    Nov 2013
    Location
    Baltimore, MD
    Posts
    899
    Add RobH2 on Thingiverse
    No, I mean 110C to 120C. Remember, it's already been hot. It's still cooling and the residual heat keeps it from getting solid.
    Bambu P1S/AMS
    NVision4D http://nvision4d.com

  3. #33
    Super Moderator RobH2's Avatar
    Join Date
    Nov 2013
    Location
    Baltimore, MD
    Posts
    899
    Add RobH2 on Thingiverse
    Quote Originally Posted by curious aardvark View Post
    @robh - here you go - not sure where you were looking it was a couple posts above my last one :-)
    Gotcha, yea, I do that too. I'm trying to do 15 things at once today so I didn't scan for that post as well as I should have.
    Bambu P1S/AMS
    NVision4D http://nvision4d.com

Page 4 of 4 FirstFirst ... 234

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •