Results 1 to 3 of 3
Thread: New to 3D printing
-
07-28-2014, 11:09 AM #1
- Join Date
- Jul 2014
- Posts
- 4
New to 3D printing
Hi I'm new to your forum, my name is John!
i have bought a Flash. Forge 3d printer the later one in the black case.
so far I have only managed to print one item completely.
everything comes loose as it warps, I have put 3M tape on the bed, but it makes no difference, this is in both types of plastic.
Can anyone help!
regards
john
-
07-29-2014, 02:42 PM #2
- Join Date
- May 2014
- Posts
- 4
I bought a flat piece of glass plate and spray hairspray, Dang if it didn't work! I've been printing for 4 months without any lifting problems, you will need to clean off the old spray every once in a while & make sure you re-level to the new depth.
-
07-31-2014, 11:53 AM #3
- Join Date
- Jun 2014
- Posts
- 63
check out the tips on flashforge section
http://3dprintboard.com/showthread.p...-Creator-forum
Printer will print perfect...
Today, 09:40 AM in Tips, Tricks and Tech Help